Options
Issue Loading Old Process / Error Re: sliding_window_validation operator
Hi All-
I'm doing an analysis that is similar to one I did waaaaay back in 2019. I tried loading a process from that old project and am getting the following error:
I've attached a copy of the process.
I see that the Sliding Window Validation (which back then was, I think, in a Time Series extension) is available in the 10.3 version of RM Studio. I'm sure this isn't trivial, but is there a way to "map" the old operator to the new one so that I can load the process?
Any/all workaround solutions would be much appreciated.
Thank you!
-Noel
I'm doing an analysis that is similar to one I did waaaaay back in 2019. I tried loading a process from that old project and am getting the following error:
I've attached a copy of the process.
I see that the Sliding Window Validation (which back then was, I think, in a Time Series extension) is available in the 10.3 version of RM Studio. I'm sure this isn't trivial, but is there a way to "map" the old operator to the new one so that I can load the process?
Any/all workaround solutions would be much appreciated.
Thank you!
-Noel
0
Best Answer
-
OptionsMartinLiebig Administrator, Moderator, Employee, RapidMiner Certified Analyst, RapidMiner Certified Expert, University Professor Posts: 3,516 RM Data ScientistHi @Noel_D ,the switch happened somewhen in RM8, so it was years ago. The series extension is still available on marketplace: https://marketplace.rapidminer.com/UpdateServer/faces/product_details.xhtml?productId=rmx_seriesIts mainly there for compatibility reasons. The bundled operators should have all the functionality in a more user friendly, more robust and faster manner.Best,Martin
- Sr. Director Data Solutions, Altair RapidMiner -
Dortmund, Germany0
Answers
which version of Studio are you running? I tried loading the process, it loads fine (albeit replacing the unknown operators with Dummy ones):
Regards,
Marco
Thank you for your reply!
I'm running 10.3.001. (I don't know if this could be relevant, but it is a trial version.)
Best,
Noel
Dortmund, Germany
Thanks for your email.
Can you provide any guidance on switching over from the "old ts extension" to the similarly named operators that come bundled with the current version of RM Studio? E.G. Are the new operators a one for one replacement, are their differences in functionality, robustness, etc.?
Best,
Noel